KROHNE IFC 020 K Installation And Operating Instructions Manual page 45

HART operating tools / Device Description (DD)
The IFC 020 can be operated either via its local operator interface or by means of the HART
communicator or the CONFIG program. Both operating tools are available from KROHNE.
Operator control by means of the HART communicator requires a device description (DD) which
we can load for you into the communicator. We can, of course, also load the DDs of all
manufacturers who have filed their DDs with the HART Communication Foundation. If you wish to
use the IFC 020 in your operating tool, for example, please ask for the description of the HART
command used so that you can address the complete IFC 020 functionality via HART.
Electrical connection
Address, e.g.:
It is essential to blank off the final signal converter's electrical bus. To do this, solder up the
semicircular circuits of solder points S6 and S7 on the amplifier PCB. For further information refer
to sections 8.8 and 8.9.
The RS 485 protocol is available. Please contact your local Krohne supplier / company.
Settings for use in interface operation
Fct. Parameter
3.08 COM
ADRESS
BAUD RATE
For further information on setting the signal converter refer to chapters 4 and 5.
Krohne RS 485 Interface
KROHNE
000-239
• 1200 • 09600
• 2400 • 19200
• 4800
Installation and operating instructions IFC 020
Krohne RS 485 Interface
Terminals:
IFC 020 E
IFC 020 K and F
6.2
6/2