Panasonic WH-ADF0309J3E5CM Service Manual page 123

CZ-RTC4 (Timer remote controller)
<If 1 indoor unit is connected to 1 remote controller>
(1) Press and hold the
for 4 seconds or longer (simple settings mode).
(2) The address is displayed for the indoor unit that is
connected to the remote controller.
(Only the address of the indoor unit that is
connected to the remote controller can be
checked.)
(3) Press the button again to return to normal
remote controller mode.
<If multiple indoor units are connected to 1 remote controller (group control)>
(1) Press and hold the
for 4 seconds or longer (simple settings mode).
(2) "ALL" is displayed on the remote controller.
(3) Next, press the
(4) The address is displayed for 1 of the indoor units
which is connected to the remote controller.
Check that the fan of that indoor unit starts and
that air is discharged.
(5) Press the button again and check the
address of each indoor unit in sequence.
(6) Press the button again to return to normal
remote controller mode.
12.1.8.7 Test Run Using the Remote Controller
CZ-RTC5B (High-spec wired remote controller)
(1) Keep pressing the
simultaneously for 4 or more seconds.
The "Maintenance func" screen appears on the
LCD display.
(2) Press the or
If you wish to see the next screen instantly, press
the or
Select "4. Test run" on the LCD display and press
the button.
Maintenance func
1. Outdoor unit error data
2. Service contact
3. RC setting mode
4. Test run
Sel.
button and
button and
button.
, and
20:30 (THU)
button to see each menu.
button.
20:30 (THU)
Page [ ] Confirm
button
button
buttons
Change the display from "OFF" to "ON" by
pressing the
the
123
Number changes to indicate which
indoor unit is currently selected.
Indoor unit address
Number changes to indicate which
indoor unit is currently selected.
Indoor unit address
20:30 (THU)
[ ]
START
CZ-RTC5B
or button. Then press
button.
Test run 20:30 (THU)
Test run
ON
Change [ ] Confirm