I/O Configuration - HMS Networks Anybus Communicator ABC4021 User Manual

® ™

I/O Configuration

Anybus Communicator - EtherCAT Slave to PROFIBUS DP Device
6.7. I/O Configuration
Figure 19. I/O configuration page
Enter the desired Size for the network input data and output data.
By default, the Communicator is set to use the same I/O sizes for both the EtherCAT and the PROFIBUS networks.
To configure different sizes for the networks, deselect the Same I/O sizes for both networks checkbox.
Endian Swap
Big-endian
The big-endian format places the most significant byte of the data at the byte with the lowest memory address.
Little-endian
The little-endian format places the least significant byte of the data at the byte with the lowest memory address.
SCM-1202-198 Version 1.0 Page 29 of 56