®
™
Anybus
Communicator
- EtherCAT Slave to PROFIBUS DP Device
10.3. Firmware Upgrade Error Management
If the firmware update process is interrupted or if the power is lost during the update process, the
Communicator goes into fallback mode.
The last working firmware is still available on the flash, but it is not active.
Procedure
To complete the interrupted firmware update:
1.
Disconnect the Communicator from power.
Figure 46. Disconnect power
2.
Reconnect the Communicator to power.
Figure 47. Reconnect power
Page 52 of 56
Firmware Upgrade Error Management
SCM-1202-198 Version 1.0