Programming; Menu Display Modes - gefran SIEIDrive ADV200 DC Series Quick Start Up Manual

7.3 Programming

7.3.1 Menu display modes

The programming menu can be displayed in two modes, which can be selected
using the Access mode parameter (04 - DRIVE CONFIG menu), see chapter 6.5.2:
• Easy (default)
• Expert
7.3.2 Programming of "function block" analog and digital input signals
The signals, variables and parameters of each single "function block" of the drive
are interconnected in order to achieve the confi gurations and controls inside the
control system.
These can be managed and modifi ed using the keypad, PC confi gurator or fi eld-
bus programming.
The programming mode is based on the following logic:
src
cfg
mon
94
only the main parameters are displayed.
all the parameters are displayed.
(source; i.e.: Ramp ref 1 src, PAR: 610)
This term defi nes the source of the function block input, i.e. the
signal to be processed in the function block.
The different confi gurations are defi ned in the relative selection lists.
(confi guration; i.e.: Mpot init cfg, PAR: 880)
This term refers to the parameter setting and its effect on the func-
tion block.
For example: Ramp times, internal reference adjustment, etc...
(display; i.e.: Ramp ref 1 mon, PAR: 620)
This term refers to the variable output from the function block,
which is the result of the calculations performed on the actual
block.
Function block
Input selected
src
ADV200 • Quick start up guide - Specification and installation
Parameter
cfg
X
Parameter
Parameter
Variable
mon