Advertisement
LED Warning Lamps
When plugging in the LED 7-Pin Warning Lamp
Connector:
1. Make sure the tractor has a good clean receptacle,
free of dirt and corrosion.
2. Make sure the LED 7-Pin Warning Lamp Connector is
inserted ALL the way in. With tighter fitting pins,
operator may think the connector is all the way in, but
really isn't.
3. Make sure the tractor receptacle cover latches over
the keyway on the LED 7-Pin Warning Lamp
Connector to hold the connector in place.
If an operator plugs in the LED 7-Pin Warning Lamp
Connector, but the lights do not seem to work right,
check the above items to make sure there is a good
connection with the LED 7-Pin Warning Lamp Connector.
Amber
Red LED Lamp
LED Lamp
LED Warning
Lights Harness
7-Pin/4-Pin
Harness
Figure 5-10: LED Warning Lamps
F-886-0322
TABLE OF CONTENTS
Amber
LED Lamp
Flasher Control
Module
Storage
1. The service life of the Folding Seeder will be extended
by proper off-season storage practices. Prior to
storing the unit, complete the following procedures:
•
Completely clean the unit, blow all seeds out of
Seed Meters.
•
Inspect the machine for worn or defective parts.
Replace as needed.
•
Repaint all areas where the original paint worn
off.
•
Apply a light coating of oil or grease to exposed
Cylinder Rods to prevent them from rusting.
•
Lubricate each point of the machine as state in
"Lubrication Maintenance" on page 5-3.
2. Protect the Folding Seeder from the weather by
storing it in a shed or under a tarpaulin. The tires
should rest on boards, or some other object, to keep
them out of the soil.
3. Store the Folding Seeder folded and fully raised with
Transport Locks engaged and pinned to prevent
settling. See "General Operation" on page 3-6.
4. Relieve Hydraulic Pressure after Transport Locks are
installed. Block Folding Seeder Transport Wheels
before unhitching from tractor.
MAINTENANCE
5-7
Advertisement
