Advertisement
ASSEMBLY
Tool Storage
Place the Calibration Crank and Wrenches in the
Toolbox. See Figure 2-11.
Toolbox
Calibration
Crank
Wrench,
1-1/2 x 1-1/8
Wrench,3"
Figure 2-11: Tool Storage
LED Warning Lamps
Installation
For shipping, the 4620-24 Folding Seeder has the left
and right hand Lamp Brackets removed to reduce
transport width.
1. Attach the Left and Right Lamp Brackets with 5/8-11
U-Bolts and Locknuts. See Figure 2-13.
IMPORTANT
Cords are marked Left or Yellow / Right or Green
2. Plug Red Lamps into Warning Lamp Harness Red
Connector.
3. Route the RH Amber Lamp Harness Connector
through the inside of the RH Lamp Bracket until it
protrudes out of the Amber Lamp Mounting Plate.
Repeat this step on the LH side.
4. Plug Amber Lamp into Warning Lamp Harness Amber
Connector.
5. Ensure when assembling Amber Lamps onto the
brackets, that the wires are not pinched when
tightening the hardware. Attach Amber Lamps with
1/4-20 x 1-1/2 Bolts, Flat Washers and Locknuts.
6. Bundle and secure any excess cord with tie wraps.
2-12
TABLE OF CONTENTS
IMPORTANT
All wires must be firmly attached to machine frame
members, or air lines, so they don't sag or become
torn loose by field debris. Use the cable and hose
ties provided.
Check to be sure that wiring at center of machine is
slack enough so as not to be stretched or interfered
with while rotating frame from transport to field
working position and vice versa.
NOTE
The 7-Pin harness connects to the tractor socket when in
use. When not in use, it can be stored in the Plug Holder
on the frame. See Figure 2-12. Allow enough harness
length to reach tractor socket and roll or fold up excess
and secure hydraulic hoses.
Items Removed
for Clarity
Plug Holder
Figure 2-12: Plug Holder
F-886-0322
Advertisement
