Advertisement
Transporting Safety
IMPORTANT
It is the responsibility of the owner/operator to
comply with all state and local laws.
•
When transporting the implement on a road or
highway, use adequate warning symbols, reflectors,
lights and slow moving vehicle sign as required. Slow
moving tractors and towed implements can create a
hazard when driven on public roads. They are
difficult to see, especially at night.
•
Do not tow an implement that, when fully loaded,
weighs more than 1.5 times the weight of the towing
vehicle.
•
Carry reflectors or flags to mark the tractor and
implement in case of breakdown on the road.
•
Do not transport at speeds over 20 MPH under good
conditions. Never travel at a speed which does not
allow adequate control of steering and stopping.
Reduce speed if towed load is not equipped with
brakes.
•
Avoid sudden stops or turns because the weight of
the implement may cause the operator to lose control
of the tractor. Use a tractor 1.5 times heavier than the
implement.
•
Use caution when towing behind articulated steering
tractors; fast or sharp turns may cause the implement
to shift sideways.
•
Keep clear of overhead power lines and other
obstructions when transporting. Know the transport
height and width of your implement. See Figure 6-1.
Safety Instructions for Towing
Vehicles
The maximum travel speed is the lesser of
•
The limit of the road conditions;
•
The maximum specified ground speed;
— for towing operations as indicated in this manual
or SIS;
— of the towed vehicle as indicated in its operator's
manual, SIS, or information sign;
•
The maximum ground speed of the towed equipment
combination shall be limited to the lowest specified
ground speed of any of the towed machines. This
speed is the ground speed limitation.
EXAMPLE: If the tractor is capable of 25 mph, the first
implement has a SIS for 19 mph, and the last
implement's operator's manual states its specified
ground speed is 15 mph, the towed equipment
combination ground speed limitation is 15 mph.
F-886-0322
TABLE OF CONTENTS
Attaching, Detaching and Storage
•
Do not stand between the tractor and implement
when attaching or detaching implement unless both
are blocked from moving.
•
Before applying pressure to the hydraulic system, be
sure all connections are tight and that hydraulic
hoses are not damaged.
•
Block implement so it will not roll when unhitched
from the tractor.
•
Relieve pressure in hydraulic circuit before
uncoupling hydraulic hoses from tractor.
NOTE
To relieve hydraulic pressure: Depending on tractor
hydraulic system, some can be relieved by actuating
control lever after engine is stopped. If tractor has electric
over hydraulic controls, it may be necessary to move the
control lever to the float position. Refer to tractor's
operator's manual.
Wear protective gloves and safety glasses or goggles
when working with hydraulic systems.
Maintenance Safety
•
Block the implement so it will not roll when working
on or under it to prevent injury.
•
Do not make adjustments or lubricate the machine
while it is in motion.
•
Make sure all moving parts have stopped.
•
Understand the procedure before doing the work.
Use proper tools and equipment.
Protective Equipment
•
Wear protective clothing & equipment appropriate for
the job. Avoid loose fitting clothing.
•
Because prolonged exposure to loud noise can
cause hearing impairment or hearing loss, wear
suitable hearing protection, such as earmuffs or
earplugs.
Tire Safety
Tire changing can be dangerous and should be
performed by trained personnel using correct tools and
equipment.
•
When inflating tires, use a clip-on chuck and
extension hose long enough to allow you to stand to
one side, not in front of or over the tire assembly.
Use a safety cage if available.
•
When removing and installing wheels use
wheel-handling equipment adequate for the weight
involved.
SAFETY INFORMATION
1-3
Advertisement
