Table of Contents
Advertisement
Finish Operation
After the operation is finished, please press the power switch at the back
right side the instrument and put it into the "O" state. Unplug the instrument
and store the instrument according to the storage guide.
Alarm System
When the normal operation is obstructed or stopped by malfunctioning,
the instrument will stop running automatically within 2 minutes and the
alarm will sound.
Power Recovery
If the power supply is cut off suddenly while the instrument is in operation,
the unit will automatically run at the previously set parameter upon power
restoration. The display window will flash. Press any button to stop flashing.
Fisher Scientific
Section 3
Operation
Nutating Mixer/3D Platform Rotator
Safety Tips and Maintenance
Section 4
Safety Tips
1. Use independent power supply.
2. Check if the local power supply voltage is suitable for use.
3. Do not drag the power supply cable when unplugging.
4. Do not use non-specified power cable nor damage cable.
5. Service should only be performed by a qualified professional.
6. The power supply must be unplugged under the following situations:
a. when the unit is moved
b. when the electrical cabinet or the moving component is opened
c. when the equipment is malfunctioning
d. when the equipment is not in use
Maintenance
a. This instrument uses a high-accuracy motor. It is maintenance free and
has a long service time, high quality, and low noise level.
b. Surfaces can be cleaned with a mild detergent and water.Liquid is not
allowed inside the dust cover.
c. Two fuses are installed inside the power socket at the back of the Nutating
Mixer Fixed Speed (One is for work and the other is for backup). The
installation of the fuses is shown in the figure below:
Warning: Avoid dripping detergent or water into the instrument during cleaning.
Fisher Scientific
3-4
Nutating Mixer/3D Platform Rotator
4-1
Advertisement
Table of Contents
