Connection - Smartgen MGC100 User Manual

6 CONNECTION

No. Function
1 B-
2 B+
3 Start Relay Output
4 Fuel Relay Output
5 Controller Types
6 High Temperature
7 Low Oil Pressure
8 Emergency Stop
9 Remote Start
10 Aux. Transistor
Magnetic Pickup 2
11 (B-) has already connected
with controller innerly.
12 Magnetic Pickup 1
13 N
14 W phase voltage monitor
15 V phase voltage monitor
16 U phase voltage monitor
MGC100 Petrol Genset Controller User Manual
Fig.2 Rear Panel
Table 6 Terminal Connection Description
Cable Size
1.0mm 2 Connected with negative of starter battery.
Connected with negative of starter battery. If wire length
1.0mm 2 is over 30m, better to double wires in parallel. Max. 10A
fuse is recommended.
B+ power is supplied by terminal 2, rated 7A.
1.0mm 2
Connected with start coil of starter.
1.0mm 2 B+ power is supplied by terminal 2, rated 7A.
When this terminal short connected with (B+), it used as
diesel genset controller.
2
1.0mm
When this terminal connected with nothing, it used as
petrol genset controller.
2
1.0mm Ground connected is active (B-).
1.0mm 2 Ground connected is active (B-).
2
1.0mm Ground connected is active (B-).
1.0mm 2 Ground connected is active (B-).
1.0mm 2 B- power is supplied by terminal 1, rated 1A.
0.5mm 2
Connected with Rotate Speed Sensor, shielding line is
recommended.
0.5mm 2
1.0mm 2 Connected with N wire.
1.0mm 2 Connected with W phase (2A fuse is recommended).
1.0mm 2 Connected with V phase (2A fuse is recommended).
1.0mm 2 Connected with U phase (2A fuse is recommended).
Note
Page 10 of 16