Objects In The Display - Korg M50-73 Owner's Manual

Introduction to the M50

Objects in the display

The M50 uses Korg's TouchView graphical user
interface.
By touching on objects shown in the display, you can
select pages, set parameter values, rename programs
and combinations, write data, and perform many other
operations.
g: Popup button (2)
a: Current page
f: Popup
button (1)
d: Edit cell
a: Current page
This indicates the current page within the selected
mode.
Beginning at the left, this area shows the mode name,
page number: name, and tab name.
Mode name Page number
b: Tab
Most pages are divided into two or more tabs.
c: Parameters
The parameters for various settings are shown in the
display.
d: Edit cell
When you touch a parameter in the display, the
parameter or parameter value will usually be
highlighted (displayed in reverse highlighting). This is
called the edit cell, and the highlighted item will be
available for editing.
For details on how to edit the value, please see
"Selecting a parameter and editing the value" on
page 17.
e: Check box
Each time you press a check box, it alternates between
the checked (red) and unchecked states.
The parameter will be active if it is checked, and
inactive if it is unchecked.
12
h: Menu
command
e: Check box
button
c: Parameters b: Tab
Tab name
f: Popup button (1)
When this button is pressed, a popup menu will
appear, showing the parameter values that are
available for selection.
To enter the parameter value, press the desired value
in the popup menu.
* Popup menu
Pin
This switches the popup menu
display between locked and
unlocked.
When locked, the pin will be shown
closed, and the popup menu will
remain displayed even after you
press a parameter value. When
unlocked, the pin will be shown
opened, and the popup menu will
close immediately when you press a
parameter value.
g: Popup button (2)
When you press this button, a tabbed menu will
appear.
To close a tabbed menu, press the OK button or Cancel
button.
Scroll bar
Use this when you need to see parameter values that
extend beyond what can be shown in the display at
one time.
Press here to scroll to left or right.
Press here and slide to left or
right to scroll to the desired
location.
h: Menu command button
* Menu
When this button is pressed, a list of menu commands
will appear.
The menu commands that appear will differ
depending on the currently selected page.
You can also select up to ten menu commands by
holding down the ENTER switch and pressing a
numeric key 0–9. The menu will close when you press
the display at a location other than the menu, or when
you press the EXIT switch.
Pin
Press here to scroll to the
corresponding location.
Menu
command
button
Menu button