Settings for the entire M50
Recalling the last-selected mode and page at
The state of M50 when the power is turned on will
depend on the setting of the Power On Mode.
If the Power On Mode is set to Reset (factory setting),
M50 will automatically select the Program mode P0:
If the Power On Mode is set to Memorize, the location
(mode and page) and the program or combination
number that had been selected when you turned off
the power will be recalled.
For details, please see "Power On Mode" on page 218
of the Parameter Guide.
Sounding a beep when you press the display
For details, please see "Beep Enable" on page 218 of
the Parameter Guide.
Protecting the memory
For details, please see "Memory protect" on page 90,
and "0–2b: Memory Protect" on page 219 of the
Global MIDI ﬁlter
MIDI-related settings for the entire M50
In the Global P1: MIDI– MIDI Basic page and the MIDI
Routing page, you can make settings for the global
MIDI channel, the Local Control on/off setting, MIDI
clock, MIDI routing, and MIDI ﬁltering.
You can also use a menu command in this page to
transmit MIDI exclusive data dumps.
For details, please see "Dump:" on page 253 of the
Pedal and other controller
In the Global P2: Controllers– Foot Controllers page
you can make the following settings.
Specifying the function of the Assignable
Switch and Assignable Pedal
For details, please see "2–1: Foot Controllers" on
page 228 of the Parameter Guide.
Setting Category Names
The Category Name pages let you assign names to the
Program and Combination categories, and sub-
Setting Category Names for Programs and
For details, please see "Global P4: Category" on
page 232 of the Parameter Guide.