Get-Started; Unpacking; Fitting The Stands (Optional); Additional Elevation Angles - Solid State Logic SSL UC1 User Manual

Get-Started

Unpacking

The unit has been carefully packed and inside the box you will find the following items in addition to your UC1 control surface:
12 volts, 5 A Power Supply
and IEC Cable

Fitting The Stands (Optional)

Additional Elevation Angles

If you need a steeper angle of elevation, you can rotate the stands and fix them to the chassis using the shorter side. This gives
you three additional angle options to choose from.
1. Unscrew the rubber feet and move to the other end
SSL UC1 User Guide
2 x Stands
1 x Hex Key
4 x Screws
2. Rotate the stands so that the short side fixes to the chassis
Long
Side
Short
Side
1.5 m C to C USB Cable
UC1 has been designed to be used with
or without the included screw-in stands,
depending on your preference. Attaching
the included screw-in stands has the added
benefit of angling the unit towards you.
Three different fixing positions (the holes
are arranged in pairs) allow you to choose
an angle that is best for your setup. Use 2
screws per stand. Please be careful not to
over-tighten to avoid stripping the screw
threads. For those with a torque measuring
device, tighten to 0.5 Nm.
Long
Side
Get-Started
1.5 m C to A USB Cable
Short
Side
7