Get-Started; Unpacking; Fitting The Stands (Optional) - Solid State Logic UF8 User Manual

Table of Contents

Get-Started

The unit has been carefully packed and inside the box you will find the following items in addition to your UF8 control surface:

12 volts, 5 A Power Supply

and IEC Cable

UF8 has been designed to be used with or without the included screw-in stands, depending on your preference. Attaching the

included screw-in stands has the added benefit of angling the unit towards you. Three different fixing positions (the holes are

arranged in pairs) allow you to choose an angle that is best for your setup. Use 2 screws per stand. Please be careful not to over-

tighten to avoid stripping the screw threads. For those with a torque measuring device, tighten to 0.5 Nm.

Additional Elevation Angles

If you need a steeper angle of elevation, you can rotate the stands and fix them to the chassis using the shorter side. This gives

you three additional angle options to choose from.

1. Unscrew the rubber feet and move to the other end

2 x Stands

1 x Hex Key

4 x Screws

2. Rotate the stands so that the short side fixes to the chassis

1.5 m C to C USB Cable

1.5 m C to A USB Cable

SSL UF8 User Guide

Table of Contents