Roland DXY-1300 Command Reference Manual page 132

Parameter P2 sets an output trigger charcter. For more information about the out­
put trigger character, see " 5.3.5 Handshake Output Specifications" . This
character is also applicable to the output of RD-GL I output commands.
(Default value: 13[CR])
EXAMPLE: P R I N T
P1 is set to 0 (default value). The output trigger character is the carriage return
ICR]CHR$(13). For example, if you send the ESC.B command to the DXY-1000
series and the carriage return [CR] thereafter, the DXY-1000 series outputs the re
maining buffer capacity to the computer.
Parameter P3 sets an echo terminator. For more information about the echo ter
minator, see " 5.3.5 Handshake Output Specifications" . The echo terminator is al
so applicable to the output of RD-GL I output commands.
(Default value: 0)
PRINT #1,CHR$
EXAMPLE:
In this example, parameters P1 and P2 are set to the default values and the echo
terminator is set to line feed [LF]CHR$(10). Thus, the computer must output the li
ne feed [LF] at the end of echo back data so that the DXY-1000 series will accept
input.
P4 and P5:
These parameters set an output terminator. The output terminator is the last
character sent following the data output by the DXY-1000 series and is made up
of one or two characters. This terminator is also applicable to the output of RD-GL
I output commands.
(Default value: 13[CR] for P4 and 0 for P5)
PRINT
EXAMPLE: ( 1 )
(2) PRINT
(1) outputs [CR]CHR$(13) as the output terminator and (2) [CR] and
[LF]CHR$(10). But in the case of two characters, as in (2), you must set P6 to 0
(default value).
P6:
This parameter sets an output initiator. For more information about the output in­
itiator, see " 5.3.5 Handshake Output Specifications" . When you set the output in­
itiator, you must set parameter P5 to 0 (default value). The output initiator is also
applicable to the output of RD-GL I output commands.
(Default value: 0)
PRINT #1,CHR$(27);".M
EXAMPLE:
This command outputs an exclamation
1000 series to the computer.
#1 ( );"
,CHR$ 2 7 .M
);"
( 2 7 .M;
, CHR$( 7
#1 2 ) ; " .M ; ; ; 1 3 : " ;
,CHR$(27)
#1
" " " (CHR$(33)) before the data sent by the DXY-
5-18
;1 :";
3
;10:";
; " . M ; ; ; 1 3 ; 1 0 : 0 : " ;
;;13;0;33:";
;