Roland DXY-1300 Command Reference Manual page 65

The CP command with no parameters provides a carriage return [CR]CHR$(13) and line feed
[LF]CHR$(10). Since the CP command designates the moving distance of the pen by the
number of character-space fields, it can be more conveniently used in printing than the PA or PR
command.
A printing example using the CP command follows. Note the flush left printing along the line.
The following example uses the CP command to draw left ju s tified characters.
EXAMPLE
100
' *** CP COMMAND ***
110
LPRINT "IN;PA3000,3000;"
120
LPRINT "SPl;SI;"
130
LPRINT "LBCP INSTRUCTION";CHR$(3)
140
LPRINT "CP-7 ,-2;PR0,0;"
150 LPRINT "LBTHE";CHR$(3)
160
LPRINT "CP;LBCHARACTER";
170
LPRINT "CP;LBPLOT";CHR$(3)
180
LPRINT "CP;LBCPINSTRUCTION,CP";CHR$(3)
190
LPRINT "SP0;"
cs
FORMAT
CS character set number [terminator]
CS [terminatorl
•DEFAULT VALUE
Designated by the DIP switch
EXPLANATION
DXY-1000 series has nineteen character sets. These are used to plot character fonts other than
English. The valid character set numbers are 0 to 4, 6 to 9, or 30 to 39. Refer to Appendix C
"Character Set Table" .
The CS command with a parameter other than these valid ones will cause an error and the com­
mand will be ignored.
If there is no parameter or the plotter is initialized, the character sets specified by the rear panel
DIP switches are selected as the standard and alternate character sets.
For the relation to the CA, SA and SS commands refer to " 3.6.2 Character Sets" in Chapter 3.
CP INSTRUCTION
THE
CHARACTER
PLOT
CPINSTRUCTION,CP
Designate Standard Character Set
(3)
CHR$
Fig. CP-3
3-21