Roland DXY-1300 Command Reference Manual page 96

When hatching is completed, the pen returns to the start position.
Hatching is performed in accordance with the current FT and PT command settings (hatching
type, shading space, angle).
EXAMPLE
100 ' • * *** HATCHING SAMPLE ***
1 . 1 0 LPRINT "SP1;FT3,130,45;"
120 LPRINT "PA;PU1000,1000;"
130 LPRINT "RA2000,2000;"
RO
FORMAT
RO rotate angle [terminator]
RO [terminator]
DEFAULT VALUE
"RO 0;''
• EXPLANATION
The RO command without parameters is equal to a parameter of 0. 0 and 90 are the only values
that are accepted as parameters. When B/A3 paper size is selected (DIP Switch 1-(7): OFF), the
X and Y axes rotates 90 degrees in a counterclockwise direction, as shown in Fig. RO-1. When
A/ A4 paper size is selected (DIP Switch 1-(7 ): ON), the X and Y axes rotate 90 degrees in a
clockwise direction, as shown in Fig. RO-2.
Scaling points P1 and P2 change as the RO command and the IP, IW commands are executed.
In Fig. RO-1, RO-2 at (3
plotter enters the default status again.
The IN command can cause the plotter to enter the default status (1) from the status in (2), (3),
but the DF command cannot.
Pressing the ENTER key on the control panel while pressing th e FAST key changes the plotter
from (1 ) to (3) in Fig. RO-1, RO-2.
Rotate Coordinate
) , if the RO, IP and IW commands without parameters are executed, the
2000 2000
( ,
Fig. RA-2
3-52
)
_____