Roland DXY-1300 Command Reference Manual page 78

The OE command can be used to learn the error contents when the POWER/ERROR LED of the
plotter is flashed.
The error mask value is set to 223 by the standard or initial setting.
The IM command with no parameter or with a parameter out of the range sets the error mask
value to the standard setting value, 223.
EXAMPLE
' * * *
IM COMMAND * * *
10
2 0 OPEN " LPT1
3 0 P R I N T #1 , " I M 2 2 2 ; "
40 P R I N T #1
IN
FORMAT
I N [ t e r m i n a t o r ]
EXPLANATION
Performs the following settings in addition to the delault settings of the DF command.
(1) Pen up (PU;)
(2) Sets the scaling points to the default values (IP;)
(3) Clears any errors and the sets the third bit of the status byte
(4) Sets the rotate coordinate system to the default values (RO;)
EXAMPLE
10 ' *** IN COMMAND ***
20 O P E N " L P T 1 :" AS #1
30 P R I N T # 1 , " I N ; "
IP
FORMAT
IP P1x,P1y (,P2x,P2y) [terminator]
PARAMETER RANGE AND DEFAULT VALUE
The parameter range will be the range of the maximum plotting area, as shown in Table IP- 1,
that can be changed by DIP switches 1-(6), 1 -
Decimal fractions are rounded down and values that are not included in Table IP-1 will be con
sidered errors.
AS #1
" X X ; "
Initialize
Input P1 and P2
( 7 ) and 1-(8).
3-34