Roland DXY-1300 Command Reference Manual page 82

LT
FORMAT
LT pattern number (, 1 pilch length) [terminator]
LT [terminator]
PARAMETER
r a n g e
Pattern number :
Pitch length : 0 to +127.9999 (%)
DEFAULT VALUE
Solid line
4%
EXPLANATION
The LT command without parameters defines a solid line. The type of dotted line varies with the
pattern number as follows:
A pattern number parameter in the range + 7 to + 1 2 7 is ignored and decimal fractions are trun
cated.
A parameter between - 128 and - 1 defaults to a solid line. A parameter greater than 128 or
less than - 1 2 8 will cause an error.
The pitch length parameter is effective when the pattern number is within +1 to + 127. This
parameter represents the pitch length as a percentage of the diagonal line between scaling
points P1 and P2.
When no pitch length is designated, it is set to 4%.
L A B E L
Line Type
- 1 2 8 to +127
Pitch length
5
0
COMMAND
Fig. LB-
(Mark with a dot at designated coordinate)
Fig. LT-1
3-38