Table of Contents
Advertisement
Installing the OPC Belt Cartridge
The OPC (Organic Photo Conductor) belt cartridge forms the image that is
developed and transferred to the media.
Attention
The OPC belt is extremely
sensitive to bright light, direct
sunlight, and touch. Always
leave it in its protective box until
you're ready to install it. Any
exposure to light should be limited to less than two minutes, or
permanent damage could result.
Also, handle the cartridge carefully so you don't touch the surface (the
green part) of the belt. The belt is extremely sensitive to hand oils and
scratches, both of which reduce print quality. This type of damage is not
covered by the product warranty.
1
Open the printer's
top cover.
5 "
If you install a duplex
unit later, you must
always open the duplex
unit's top cover first.
2
Rotate up the two lock
levers to prepare the open-
ing for the cartridge.
3
Remove the OPC belt
cartridge from its protec-
tive bag.
4
Pull out the two
tension-release
pins (A) (one on
each side of the
cartridge).
5
Remove the protec-
tive sheet (B) from
the cartridge.
5 "
Setting up Your Printer
The white powder lubricant on a new OPC belt is normal; it
won't affect quality.
A
B
A
15
Advertisement
Table of Contents
