Mounting Xv2-22H - Cambium Networks XE5-8 Hardware Installation Manual

Mounting XV2-22H

The XV2-22H units are mounted by using one of the following mounting techniques:
Single gang mounting, or
⚫
Wall mounting
⚫
Single gang mounting
1. Place single-gang wall bracket on the gang box and secure with at least 2 screws.
2. Connect the Ethernet cable to the upper RJ-45 port labeled Eth1/PoE at the rear side of XV2-22H
to provide connectivity. Use the other RJ-45 port labeled Pass-Through for any additional cable
that might need to pass through XV2-22H.
3. Align the two slots on the rear side of the XV2-22H with two hooks on the bracket.
4. Secure XV2-22H to the bracket with a screw at the bottom edge of XV2-22H using a standard Torx
security screw or standard Philips head screw.
Chapter 2: Packaging and Installation of Access Point 48