Specific Expertise And Training Required For Professional Installers; Avoidance Of Weather Radars; Ethernet Networking Skill; Ethernet Cabling Types - Cambium Networks XE5-8 Hardware Installation Manual

les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement pour une utilisation à
l'intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites mobiles
utilisant les mêmes canaux.
For indoor use only. Pour une utilisation en intérieur uniquement.
ISED Radiation Exposure Statement
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 31 cm between
the radiator and your body.
Cet équipement est conforme aux limites d'exposition aux rayonnements IC établies pour un
environnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 31 cm de
distance entre la source de rayonnement et votre corps.
Specific expertise and training required for professional
installers
To ensure that the Enterprise Wi-Fi 6 AP is installed and configured in compliance with the requirements
of Industry Canada and the FCC, installers must have the radio engineering skills and training described in
this section. This is particularly important when installing and configuring an Enterprise Wi-Fi 6 AP
system for operation in the 5 GHz band (5150 – 5250 MHz – FCC only, 5250 – 5350 MHz, 5470 – 5725
MHz, 5725 – 5850 MHz and 5925 - 6425 MHz).

Avoidance of weather radars

The installer must be familiar with the requirements in FCC KDB 443999. Essentially, the installer must be
able to:
Access the FCC database of weather radar location and channel frequencies.
⚫
Use this information to correctly configure the product (using the UI) to avoid operation on
⚫
channels that must be avoided according to the guidelines that are contained in the KDB and
explained in detail in this user guide.
In ETSI regions, the band 5600 MHz to 5650 MHz is reserved for the use of weather radars.
⚫

Ethernet networking skill

The installer must have the ability to configure IP addressing on a PC and to set up and control products
using a web browser interface.

Ethernet cabling types

Following are the recommended Ethernet cabling types for various APs which has Multi-gigabit capable
Ethernet ports:
XV3-8 and XE5-8 (5Gbps)
⚫
XV2-2, XE3-4, and XV2-2T (2.5Gbps)
⚫
For 2.5Gbps, Cambium Networks recommends CAT6 cable or better to cover the 100m maximum cable
length runs. For shorter runs under about 30m, CAT5E cable is recommended. For high radio-frequency
electric fields environments, shielded CAT5E or CAT6 type cabling is recommended.
Chapter 1: About This User Guide 13