Mounting Xv2-2 - Cambium Networks XV3-8 Hardware Installation Manual

Mounting XV2-2

Ceiling Mount:
Screws x 4
1. Determine where XV2-2 needs to be mounted and remove the ceiling tile.
2. Using the hole template, mark the hole locations.
3. Drill the holes for the 4 mounting screws using a 5mm (3/6") diameter drill bit.
4. Drill the RJ45 cable hole using a 15 mm (5/8") diameter bit.
5. Hold the mounting plate on the top side of the ceiling tile and screw it on the mounting bracket.
6. Run the RJ45 cable/cables through the 15mm hole and remount the ceiling tile.
7. Attach the RJ45 cable/cables to XV2-2.
8. Slide XV2-2 into the mounting bracket.
Packaging and Installation of Access Point
Enterprise Wi-Fi AP Hardware Installation Guide
Mounting Plate
Mounting Bracket
Ceiling Tile
18