Spectre 3.0 Integra Features - SINGULARITY COMPUTERS Eclipse Series Assembly Manual

Spectre 3.0 Integra Features

Integrated Liquid Cooling Features
•
Reservoir, D5 Pump Top, D5 Pump Cover, Fill Port, Drain Port, parts of the cooling loop.
PowerBoard Integration
•
The PowerBoard is a PCB integrating 24pin, PCIE and EPS along with PWM and ARGB Hubs,
SATA and Power and Reset Buttons. The Spectre 3.0 Integra PowerBoard also has an integrated
touch sensing Power Button. The PowerBoard has x20 ARGB LEDs positioned around the
external and internal perimeter to optimally light up the distribution plate. Essentially the
PowerBoard is a distribution plate for cables also integrating other features and functions. It
is a new method for cables allowing standardization of cable lengths and making cable
management no longer necessary. Spectre 3.0 Integra comes included with a standard set of
black sleeved linking cables including 24pin x1, 8pin EPS x2, 8pin PCIE x3 meaning that these
cables don't have to be purchased separately.
Reduced build time due to integration
•
With the pump, reservoir, fill and drain ports, half of the water-cooling loop, the core
component cables, PWM and ARGB hubs all integrated there is less assembly to be done. Also,
less fittings and tube are needed. No cable management for the core component cables thanks
to the PowerBoard integration.
Integration Cost Component
•
A large portion of the case cost is due to the integration. These are components you do not
have to purchase for your build. The pump top, reservoir, cables, hubs, less fittings, less tube,
no cable combs, or cable management components.
Compatibility
•
Theoretically the more integration the less compatibility. For Spectre Integras integration,
each port and connector were positioned based on an average of a vast range of components.
Integration & Optimization
•
With the integration we did not just develop a case, we also developed all the integrated
components. This meant that we could focus more on optimization than would normally be
possible. The integrated loop routes in Spectre allow for more flow than 16mm tubes. The
pump top was designed for the D5 pump, maximizing flow to and from the distribution plate.
The reservoir was designed to remove air as quickly as possible making the loop easier to fill.
The fill port is at the highest point on the back for the case and the drain point at the lowest
point.
High End Components
•
Spectre 3.0 Integra fits XL-ATX motherboards and has 8 expansion slots. It is designed for fit
the largest high-end GPUs. It can fit the largest PSUs up to 220mm. For the water-cooling
Revision 2.2
Spectre 3.0 Integra, Integra Umbra Limited Edition &
Integra Umbra Chrome Elite Limited Edition Assembly Manual
Page | 4