Error Codes; When Sending Faxes - Konica Minolta PagePro 1390 MF User Manual

Error Codes

When Sending Faxes

As a default, the transmission result is printed when a fax transmission fails.
Check the 6-digit error code that appears in the Result column.
Error code
xxx015
xxxx16, xxxx17,
xxxx31
xxxx30-xxx79
xx0130-xx0179 If errors often occur with
70
Cause
This code indicates that
no dial tone was
detected.
This code indicates that
the fax signal was not
received after dialing.
This code indicates that
the fax transmission was
started but could not be
completed correctly.
these error codes, the
quality of your tele-
phone line is not good
enough to operate in
V34 mode.
Solution
Press the [On Hook] key and lis-
ten for the monitoring sound.
If you cannot hear the monitoring
sound, the telephone line is not
correctly connected to the LINE
jack. (There are two connectors,
one for an external telephone
and one for the telephone line),
(page 2).
Check that the remote fax num-
ber is correct.
If the number is correct, then try
increasing the setting for Connect
Time in the Fax Main. menu of
Fax Setup (page 6).
First, try sending the pages
again. Sometimes the telephone
line quality improves and the
transmission can be completed
correctly.
If this error occurs frequently, you
may need to adjust the setting in
the Fax Main. menu of Fax Setup
(page 6).
Try changing the setting for Tx
Speed from 33.6 Kbps to 14.44
Kbps, and then check the results.
Tx Speed is available in the Fax
Main. menu of Fax Setup (page
6).
Error Codes