Relocating The Power Cord - Wine Guardian WG25 Installation, Operation And Maintenance Manual

重新安置电源线

Relocating the power cord

30
1.卸下每个盖板底部的两个螺钉，从设备两
端卸下面板。向下拉每个盖板，使其脱离本
机。
1. Remove Face Plates from both ends of unit
by removing two screws at the base of each
cover. Pull each cover down and away from
unit.
2.如图所示，在设备的冷凝器端（暖风侧）
从机箱上拧下接地片，并拔下连接到电源线
的绿线。
2. At the condenser end (warm air side) of the
unit unscrew the ground lug from chassis and
remove the green wire connected to the power
cord as shown.
3.如图所示，将接地片重新连接到机箱上，
并确保另外两根绿色的接地线已固定并重新
连接到机箱上。
3. Re-attach the ground lug onto the chassis and
ensure the other two green ground wires are
secure and attached back onto the chassis as
shown.
4.使用钳子或平头螺丝刀推入将电源线固定
在机箱支架内的索环侧面的卡舌。下拉电源
线以从支架上松开。可以旋转电源线，以便
更轻松地访问标签
4. Use pliers or flat blade screw driver to push
in the tab on the side of the grommet that holds
the power cord within the chassis bracket. Pull
down on power cord to release from bracket.
Power cord can be rotated for easier access to
tab.