遥感器配对说明-多个传感器（无线 - Wine Guardian WG25 Installation, Operation And Maintenance Manual

遥感器配对说明—多个传感器（无线）
图 1
图 2
64
If using multiple remote temperature/humidity sensors in your application, refer
to the figures and the procedure below to change each remote sensor's device
number (Three Remote Sensors maximum). Each Remote Sensor must have its
own device number and must also be on the same RF channel (Setting 31) as the
system they are being paired with.
如您在应用中使用多个远程温度/湿度传感器，请参考下面的图片和步骤来
更改每个遥感器的设备号（最多三个遥感器） 。每个遥感器必须拥有其自己
的设备号，且必须处于同一 RF 频道（设置 31） ，因为该频道为遥感器与系
统配对的频道。
1. To change the remote sensor's device number, see the following
instructions:
1. 如须更改遥感器设备号，请见以下说明：
a. Use a pin to press the button for about half a second and release (Fig. 1).
用别针按住按钮约半秒钟，然后松开（图 1） 。
a.
b. Observe the LED on the side of the remote sensor (Fig. 2). The LED will
flash once for a Device #1, twice for a #2, three times for a #3. At any
time, while in this mode press the button once to change the device
number. Once each remote sensor has its own unique device number
simply wait for the LED to stop flashing and the setting will be saved.
观察遥感器一侧的 LED 灯（图 2） 。1 号设备 LED 灯闪一次，2 号
b.
设备 LED 灯闪 2 次，3 号设备 LED 灯闪 3 次。在此模式下，可随时
按下按钮以更改设备号。各遥感器的设备号设置完成后，LED 灯将
停止闪烁，说明设置已被保存。
2. 如须更改遥感器 RF 频道，请见以下说明：