Table of Contents
Advertisement
SAFETY
NOTICE
RLL (Rated Lifting Load) for the link may not be the same as the lifting capacity of the machine. Al-
ways be sure to lift within the relevant lifting limits.
•
The lifting link RLL (Rated Lifting Load) and part number are stamped on the link as shown below.
•
All components in the load line (eg. chains, shackles etc.) must be rated correctly for the load to be lifted.
•
When swinging or operating the work equipment, check carefully that the surrounding area is clear from ob-
jects, structures or any persons working around the machine.
•
During the lifting operation, reduce the engine speed and
carry out the operation in L mode.
•
Never travel the machine while lifting the load.
•
Do not swing or operate the work equipment suddenly.
There is a danger that this may cause the load to swing
and the machine to become unstable or tip over.
•
Do not leave the operator seat when there is a raised load.
•
If the load approaches the lifting limit of the machine, a
warning is shown on the monitor panel and an audible
alarm sounds. In this case, lower the load to the ground.
(A) RLL (Rated Lifting Load) number.
(B) Part number.
•
Do not use the work equipment or swing to pull the load in
any direction.
There is a danger that the lifting eye may be damaged due to
abnormal loading making it unsafe to lift.
WENAM00111
PRECAUTIONS FOR OPERATION
2-37
Advertisement
Chapters
Table of Contents
