HP Apollo 2000 Maintenance And Service Manual page 44

Remove the FlexibleLOM 1U node riser cage assembly.
5.
CAUTION:
PCI riser cages or rear I/O blanks are installed, and do not operate the node unless all PCI slots
have either an expansion slot cover or an expansion board installed.
Single-slot 2U node PCI riser cage assembly
To remove the component:
Power down the node (on page 27).
1.
Disconnect all peripheral cables from the node.
2.
Remove the node from the chassis (on page 27).
3.
Place the node on a flat, level surface.
4.
Remove the FlexibleLOM 2U node riser cage assembly (on page 45).
5.
To prevent improper cooling and thermal damage, do not operate the node unless all
Removal and replacement procedures 44