HP Apollo 2000 Maintenance And Service Manual page 77

Clean the old thermal grease from the heatsink with the alcohol swab. Allow the alcohol to evaporate
5.
before continuing.
Apply all the grease to the top of the processor in one of the following patterns to ensure even
6.
distribution.
Install the heatsink:
7.
Position the heatsink on the processor backplate.
a.
Tighten one pair of diagonally opposite screws halfway, and then tighten the other pair of screws.
b.
Finish the installation by completely tightening the screws in the same sequence.
c.
Install the air baffle.
8.
Install any removed PCI riser cage assemblies.
9.
Install the node into the chassis.
10.
Connect all peripheral cables to the node.
11.
Power up the node.
12.
Removal and replacement procedures 77