Biss Safety Serial Interface; Siemens Drive-Cliq Serial Interface - Renishaw FORTiS-S FS Installation Manual

9.4 BiSS Safety serial interface

BiSS Safety specifications
Power supply for each readhead 5 V ±10%
Ripple

9.5 Siemens DRIVE-CLiQ serial interface

Included with Siemens-only versions of FORTiS.
Siemens DRIVE-CLiQ specifications
Power supply for each readhead
24 V
Ripple
Maximum total cable length
Connector tightening torque
Vibration (interface)
Environment protection (interface)
1.25 W maximum (250 mA @ 5 V)
NOTES:
1. Current consumption figures refer to terminated FORTiS systems. Renishaw
encoder systems must be powered from a 5 Vdc supply complying with the
requirements for SELV of standard IEC 60950-1.
2. Over voltage protection ±10 V.
200 mVpp maximum @ frequency up to 500 kHz
1.8 W maximum (75 mA @ 24 V), 24 V as per DRIVE-CLiQ specification.
24 V power is provided by the DRIVE-CLiQ network
NOTE: Over voltage protection –36 V to +36 V.
200 mVpp maximum @ frequency up to 500 kHz
Readhead to DRIVE-CLiQ interface 9 m
(Refer to Siemens DRIVE-CLiQ specifications for maximum cable length from
interface to the controller)
Extension cables from the FORTiS-S FS DRIVE-CLiQ interface to the controller
should be sourced directly from Siemens
M12 – 4 Nm
< 100 m/s to IEC 60068-2-6
2
IP67
www.renishaw.com 15