NAPCO Gemini GEM-P1632 Programming Instructions Manual page 42

Page 42
Configuring the GEM-RP2ASe2 Keypad
Up to 7 GEM-RP2ASe2 keypads may be connected to the panel (Keypads 1–7). Each must be configured for a keypad
address. In addition, the keypad may be configured to disable (a) touch pad back light; (b) LCD back light; and (c) entry
sounder. Keypads are configured by the proper selection of jumpers. Refer to the label on the circuit board fishpaper
(LA1390) for jumper locations and a summary of settings.
KEYPAD NUMBER
KEYPAD
NUMBER
1 2 3
1 OFF or OFF OFF
ON*
2 OFF ON OFF
3 ON ON OFF
4 OFF OFF OFF
5 ON OFF ON
6 OFF ON ON
7 ON ON ON
tion.
TOUCH PAD BACK LIGHT
Cut Jumper A to disable touch pad backlighting to conserve 11mA standby current.
LCD BACK LIGHT
Cut Jumper B to disable LCD backlighting.
KEYPAD SOUNDER
Cut Jumper C to disable the sounder. (Do not disable in UL applications.)
GEM-P1632 Programming Instructions
KEYPAD ADDRESS
If more than one keypad is installed:
Each must be assigned a unique address (that is, no two keypads may be
PARK
numbered alike).
Keypads must be addressed consecutively (that is, missing numbers are not
permitted).
Only Keypad No. 1 may be used for programming. (However, for ease of
STORE SPARE
programming, it is recommended that a GEM-RP1CAe2 be selected as Keypad
JUMPER AT THIS
POSITION
#1.)
Assign the keypad address number by selecting Jumpers J1–3 in accor-
dance with the table at left.
*Note: (1) Keypads are factory supplied with no jumpers installed and a as
such are automatically configured as Keypad No. 1. (2) Only one keypad in
the system may be configured as Keypad No. 1, otherwise none will func-
NAPCO Security Systems, Inc.
333 Bayview Avenue, Amityville, New York 11701
For Sales and Repairs, call toll free: (800) 645-9445
For direct line to Technical Service, call toll free: (800) 645-9440
Internet: http://www.napcosecurity.com
WI897B 8/98
NAPCO Security Systems