NAPCO Gemini GEM-P1632 Programming Instructions Manual page 41

WI897B 8/98

Press the button to continue or press the
designate the keypad as Group "01" at the "
number "01" through "06". (Each EZM must have a unique assigned group number, starting with "01" and proceeding
consecutively.) Press the
Zone Response
The normal loop response of each keypad expansion zone is 750mS, however the response time of any zone can be
Example. Change Zones 2, 3 and 4 to 50mS response.

1. Circle numbers for Zones 2, 3 and 4: (2), (4) and (8).
2. Add up the circled numbers: 2 + 4 + 8 = 14.
3. Enter "14" at the keypad, then press the
Press the button to continue or press the

Press the button to continue (the display will loop back through selections, for changes) or press the
to exit the Keypad Configuration Mode (display will read "
(top two).
NAPCO Security Systems
Compatibility Number (Not Applicable)


THIS FEATURE IS NOT COMPATIBLE WITH THE GEM-P1632 CONTROL
PANEL.
EZM Address
The keypad's internal EZM (Expansion Zone Module) may be utilized to
provide four additional wired zones. Whether used alone or in conjunction
with optional GEM-EZM series modules or other keypad EZMs, it must be
assigned a unique address (or Group number, see Keypad Programming

Workbook) similar to its keypad address. If no other EZMs are to be used,
button to continue or press the
reduced to 50mS as follows.
1. Of the following, circle the number(s) in parentheses associated with the
zone(s) to be changed:
Zone 1=(1); Zone 2=(2); Zone 3=(4); Zone 4=(8)
2. Add up the circled numbers.
3. At the keypad, enter the sum as a two-digit number "01" through "15" on
the display, then press the


button.
Program Control Message (Not Applicable)
THIS FEATURE IS NOT COMPATIBLE WITH THE GEM-P1632 CONTROL
PANEL.
button to exit.


" display. In multiple-EZM systems, enter an assigned group
button to exit.
button.
button to exit.
"). Then replace Jumper JP5 across Pins 1–2
GEM-P1632 Programming Instructions
Page 41


button