Safety Check; Emergency-Stop Push Button; 1.11.1 Main Switch - Optimum OPTidrill DH 24BV Operating Manual

1.10

Safety check

Check the drilling machine before each start-up or at least once per shift. Inform the person
responsible immediately of any damage, defects or changes in the operating function.
Check all safety devices
at the beginning of each shift (with the machine stopped),

once a week (with the machine in operation),

after all maintenance and repair work.

Check that prohibition, warning and information signs and the labels on the drilling machine.
are legible (clean them, if necessary),

are complete (replace if necessary).

INFORMATION
Organise the checks according to the following table;
General check
Equipment
Protective covers
Signs,
Markers
Date:
Functional check
Equipment
EMERGENCY-STOP
push button
Drill chuck protection
Date:
1.11

EMERGENCY-STOP push button

ATTENTION!
Also after actuating the EMERGENCY-STOP switch, the drilling spindle is turning -
depending on the previously selected speed - for a few seconds more.

1.11.1 Main switch

In the "0" position, the lockable main switch can be secured against accidental or non-author-
ised switching on by means of a padlock.
The power supply is interrupted by switchingoff the main plug.
Except for the areas marked by the pictogram in the margin. In these areas there might be volt-
age, even if the main switch is switched-off.
EN
DH24BV | DH28BV | DH34BV | DH40BV
74
Check
Mounted, firmly bolted and not damaged
Installed and legible
checked by (signature):
Check
After actuating an EMERGENCY STOP push button the
drilling machine must be switched off.
The drilling machine must only be switched on, if the drill
chuck protection is closed. The engine must switch off when
the drill chuck protection is opened during operation.
checked by (signature):
Translation of original instruction
OK
OK
Safety
Version 1.1.4 - 2022-09-14