Program Table Edit/Save (Fnb03) - YASKAWA E-7 Series Operating Manual

3.2 Operating Procedures for Utility Functions

3.2.34 Program Table Edit/Save (FnB03)

3.2.34 Program Table Edit/Save (FnB03)

This function edits and saves program tables. Saving a program table to
flash memory after editing it ensures that the data will be retained even
after the control power has been turned off.
 Codes Displayed on the Program Table Editing
Screen
Refer to the following manual for information on interpreting the dis-
plays.
PGM-
STEP
0
1
255
Preparation
Always check the following before you edit or save a program table.
• The parameters must not be write-prohibited (Fn010 must be set to
0000).
• The program must not be running or on hold.
• A program table save operation must not be in progress for any
means other than the digital operator.
• Execution of the RES command must not be in progress.
Editing Program Table
The operating procedure when setting the acceleration (ACC) in pro-
gram step 5 is explained here.
Step
1
3-108
Σ-7-Series Σ-7S SERVOPACK Command Option Attachable Type with
INDEXER Module Product Manual (Manual No.: SIEP S800001 64)
POS SPD RDST RSPD ACC DEC POUT EVENT LOOP
POS000 SPD000 RDST000 RSPD000 ACC000 DEC000 POUT000
POS001 SPD001 RDST001 RSPD001 ACC001 DEC001 POUT001
POS255 SPD255 RDST255 RSPD255 ACC255 DEC255 POUT255
Operation
Press the key to open the Utility
Function Mode main menu, and
move the cursor with the
keys to select FnB03.
EVT000 LOOP000
EVT001 LOOP001
EVT255 LOOP255
Result
Continued on next page.
NEXT
NEXT000
NEXT001
NEXT255