Hartzell HC-82XF-1 Owner's Manual page 37

(11) Propeller ice protection system components not supplied by
Hartzell Propeller Inc. are controlled by the applicable TC
or STC holder's Instructions for Continued Airworthiness
(ICA).
CAUTION:
(12) The information in this manual supersedes data in all
previously published revisions of this manual.
(13) The airframe manufacturer's manuals should be used in
addition to the information in this manual due to possible
special requirements for specific aircraft applications.
(14) Approved corrosion protection followed by approved paint
must be applied to all aluminum blades.
(a) For information concerning the application of corrosion
protection and paint, refer to the Maintenance Practices
chapter of this manual.
(b) Operation of blades without the specified coatings and
finishes, i.e., "polished blades", is not permitted.
C. Continued Airworthiness
(1)
Operators are urged to stay informed of airworthiness
information via Hartzell Service Bulletins and Service
Letters which are available from Hartzell distributors,
or from the Hartzell factory by subscription. Selected
information is also available on Hartzell Propeller's web site
at www.hartzellprop.com.
Propeller Owner's Manual
DO NOT USE OBSOLETE OR OUTDATED
INFORMATION. PERFORM ALL
INSPECTIONS OR WORK IN ACCORDANCE
WITH THE MOST RECENT REVISION OF
THIS MANUAL. INFORMATION CONTAINED
IN THIS MANUAL MAY BE SIGNIFICANTLY
CHANGED FROM EARLIER REVISIONS.
FAILURE TO COMPLY WITH THIS MANUAL
OR THE USE OF OBSOLETE INFORMATION
MAY CREATE AN UNSAFE CONDITION THAT
MAY RESULT IN DEATH, SERIOUS BODILY
INJURY, AND/OR SUBSTANTIAL PROPERTY
DAMAGE. FOR THE MOST RECENT
REVISION LEVEL OF THIS MANUAL, REFER
TO THE HARTZELL WEB SITE AT
WWW.HARTZELLPROP.COM.
INTRODUCTION
175
61-00-75
Rev. 1 Jun/11
Page 1-7