Hartzell HC-82XF-1 Owner's Manual page 139

CAUTION:
(8) Carefully slide the spinner dome over the installed
propeller.
(9) To properly position the rear bulkhead, temporarily install
the spinner dome with at least four screws.
(10) Adjust the spinner to equalize the clearance between the
blades and the blade cutouts in the dome.
(11) Remove the spinner dome.
(12) Using tool BST-2910, torque the propeller shaft nut
(Table 3-1). Refer to Table 3-2 and Figure 3-4 to
determine the proper torque value to which the torque
wrench must be set.
D-2020
Bushing
Hub
Safetying the Shaft Nut on the 20 Spline Shaft Propeller
INSTALLATION AND REMOVAL
Propeller Owner's Manual
TO PREVENT DAMAGE TO THE BLADE
AND BLADE PAINT, WRAP THE BLADE
SHANKS IN SEVERAL LAYERS OF
MASKING OR DUCT TAPE BEFORE
INSTALLING THE SPINNER DOME.
REMOVE THE TAPE AFTER THE
SPINNER IS INSTALLED.
Puller Ring
Cylinder O-ring
Figure 3-14
175
Shaft Nut
Safety Pin
61-00-75
Piston
Page 3-59
Rev. 1 Jun/11