Hartzell HC-82XF-1 Owner's Manual page 129

(a) Manual 180 (30-61-80) - Propeller Ice Protection
System Manual
(b) Manual 181 (30-60-81) - Propeller Ice Protection
Component Maintenance Manual
(c) Manual 182 (61-12-82) - Propeller Electrical De-ice
Boot Removal and Installation Manual
(d) Manual 183 (61-12-83) - Propeller Anti-icing Boot
Removal and Installation Manual
(15) Propeller ice protection system components not
supplied by Hartzell Propeller Inc. are controlled by the
applicable TC or STC holder's Instructions for Continued
Airworthiness (ICA).
(16) Install the spinner dome as follows:
NOTE:
CAUTION 1:
CAUTION 2:
(a) Carefully slide the spinner dome over the installed
propeller.
(b) Secure the spinner dome to the spinner bulkhead
with the supplied screws and washers.
INSTALLATION AND REMOVAL
Propeller Owner's Manual
175
The following instructions relate to Hartzell
spinners only. In some cases, the airframe
manufacturer produced the spinner assembly.
In those cases, refer to the airframe
manufacturer's manual for spinner installation
instructions.
TO PREVENT DAMAGE TO THE
BLADE AND BLADE PAINT, WRAP THE
BLADE SHANKS IN SEVERAL LAYERS
OF MASKING OR DUCT TAPE
BEFORE INSTALLING THE SPINNER
DOME. REMOVE THE TAPE AFTER
THE SPINNER IS INSTALLED.
THE SPINNER DOME WILL WOBBLE
IF NOT ALIGNED PROPERLY, AND
MAY AFFECT THE BALANCE OF THE
PROPELLER.
61-00-75
Page 3-49
Rev. 1 Jun/11