Hartzell HC-82XF-1 Owner's Manual page 147

WARNING:
(3) Clean the propeller hub spline and engine spline
surfaces with Quick Dry Stoddard Solvent or MEK.
(4) Slide the spinner bulkhead onto the shaft.
(5) Install the rear cone onto the bulkhead (Figure 3-39),
matching the holes in the cone with the pins in the
bulkhead.
(6) Retract the start lock pins and hold them in place with a
heavy wire inserted through the hole of each start lock
housing.
(7) Install the rear cone O-ring (Table 3-1) over the shaft.
(Refer to Figure 3-19).
D-2020
Cylinder
Spring
Spring Assembly-to-Cylinder Installation Details
INSTALLATION AND REMOVAL
Propeller Owner's Manual
175
CLEANING AGENT MEK IS FLAMMABLE
AND TOXIC TO THE SKIN, EYES AND
RESPIRATORY TRACT. SKIN AND EYE
PROTECTION ARE REQUIRED. AVOID
PROLONGED CONTACT. USE IN A WELL
VENTILATED AREA.
Figure 3-18
Split Retainer
Feathering Stop
Feathering Stop Screw
Safety Wire
Ring Retention Plate
61-00-75
Page 3-67
Rev. 1 Jun/11