Hartzell HC-82XF-1 Owner's Manual page 113

(10) Safety all mounting bolts with 0.032 inch (0.810 mm)
minimum diameter stainless steel wire (two bolts for
each safety).
(11) Procedure for reinstallation of the piston nut, if applicable.
(a) Following the installation of the propeller, retract the
start lock pins and hold them in place with a heavy wire
inserted through the hole of each start lock housing.
(b) Carefully push the piston toward the engine, rotate the
blades to feather position, and attach the piston nut to
the pitch change rod.
(c) Use a breaker bar and a 5/8 inch deep well socket to
hold the pitch change rod.
(d) Using a 1-13/16 inch crowfoot wrench and a torque
wrench, torque the piston nut. Refer to Table 3-2 and
Figure 3-4 for the proper torque value.
NOTE:
(12) Remove the wires from the start lock brackets.
CAUTION:
(13) Position the propeller on the start locks.
(a) Using the blade paddles, slowly rotate the blades
simultaneously toward low pitch until the start lock
pins engage the start lock plates.
INSTALLATION AND REMOVAL
Propeller Owner's Manual
175
The removal and subsequent reinstallation
of the piston nut does not require that the
propeller blade angles be rechecked.
DO NOT PUT THE BLADE PADDLE
IN THE AREA OF THE DE-ICE BOOT
WHEN APPLYING TORQUE TO A BLADE
ASSEMBLY. PUT THE BLADE PADDLE IN
THE THICKEST AREA OF THE BLADE,
JUST OUTSIDE OF THE DE-ICE BOOT.
USE ONE BLADE PADDLE FOR EACH
BLADE.
61-00-75
Page 3-33
Rev. 1 Jun/11