Hartzell HC-82XF-1 Owner's Manual page 148

(8) Install the rear cone and bulkhead on the shaft.
(9) With a suitable crane hoist and sling, carefully move the
propeller assembly to the aircraft engine mounting flange
in preparation for installation.
NOTE:
(10) Slide the propeller hub onto the shaft and tighten the
shaft nut until the rear bulkhead is snug, but not tight.
CAUTION:
(11) Carefully slide the spinner dome over the installed
propeller.
D-2020
Spinner Bulkhead
Rear Cone O-Ring
Rear Cone
Bulkhead Pin
Spline Engine Shaft
INSTALLATION AND REMOVAL
Propeller Owner's Manual
If the propeller is equipped with an anti-ice
or a de-ice system, follow the applicable
manufacturer's instructions for installation of
the anti-ice or de-ice system hardware.
TO PREVENT DAMAGE TO THE BLADE
AND BLADE PAINT, WRAP THE BLADE
SHANKS IN SEVERAL LAYERS OF
MASKING OR DUCT TAPE BEFORE
INSTALLING THE SPINNER DOME.
REMOVE THE TAPE AFTER THE
SPINNER IS INSTALLED.
Rear Hub Mounting Parts
Figure 3-19
175
61-00-75
Rev. 1 Jun/11
Page 3-68