Hartzell HC-82XF-1 Owner's Manual page 138

(5) Install the rear cone O-ring (Table 3-1) over the shaft and
against the cone. Refer to Figure 3-13.
WARNING:
CAUTION:
(6) With a suitable crane hoist and sling, carefully move the
propeller assembly to the aircraft engine mounting shaft.
NOTE:
(7) Slide the propeller hub onto the engine shaft and tighten
the hub nut until the rear bulkhead is snug, but not tight.
Do not torque the nut.
D-2721
Rear Cone O-Ring
Bulkhead Pin
Spline Engine Shaft
INSTALLATION AND REMOVAL
Propeller Owner's Manual
MAKE SURE THE SLING IS RATED UP TO
800 POUNDS (363 KG) TO SUPPORT THE
WEIGHT OF THE PROPELLER ASSEMBLY
DURING INSTALLATION.
WHEN INSTALLING THE PROPELLER
ON THE AIRCRAFT, DO NOT DAMAGE
THE ICE PROTECTION SYSTEM
COMPONENTS, IF APPLICABLE.
In most cases, the piston is not installed on
the cylinder when the propeller is not installed
on the engine.
Spinner Bulkhead
Rear Cone
Rear Hub Mounting Parts
Figure 3-13
175
61-00-75
Rev. 1 Jun/11
Page 3-58