Hartzell HC-82XF-1 Owner's Manual page 168

(5) Remove the propeller mounting bolts and washers.
NOTE:
CAUTION:
(6) Using the support sling, lift the propeller from the
mounting flange.
(7) Remove and discard the shaft O-ring.
(8) Put the propeller, with spinner bulkhead and start locks
attached, on a suitable cart for transportation.
(9) If spinner assembly 837-16 is installed, refer to Figure
3-45 and perform the following steps for the spinner
bulkhead removal.
(a) Record the position of each start lock in relation to
its matching blade.
(b) Remove the bolts, nuts, and washers that attach the
bulkhead to a ring and spinner mounting plate.
(c) Remove the two-piece spinner mounting plate,
spinner bulkhead, and ring from the engine flange.
INSTALLATION AND REMOVAL
Propeller Owner's Manual
For propeller removals between overhaul
intervals, mounting bolts and washers may be
reused if they are not damaged or corroded.
USE ADEQUATE PRECAUTIONS TO
PROTECT THE PROPELLER ASSEMBLY
FROM DAMAGE WHEN IT IS REMOVED
FROM THE AIRCRAFT ENGINE AND
WHEN IT IS STORED.
175
61-00-75
Rev. 1 Jun/11
Page 3-88