Diagnostic Trouble Codes (Dtc) - Raven VSN Operation Manual

CHAPTER 6

DIAGNOSTIC TROUBLE CODES (DTC)

Diagnostic Trouble Codes
TABLE 3.
Code ID
523865 .31
523872 .31
523929 .31
523930 .31
523931 .13
523932 .13
523933 .31
523934 .31
523935 .31
523936 .31
523937 .13
523938 .31
523939 .31
523940 .31
523941 .31
523942 .31
524194 .31
48
Description
No ethernet connection.
SC1 ECU out of date.
Row guidance failed.
Video control failed.
Bad calibration file.
Radar sensors not configured.
Left radar sensor offline.
Right radar sensor offline.
Stand-alone height sensor out of
date.
ABM ECU version out of date.
ABM ECU not calibrated.
Dynamic height sensor offline.
Both radar sensors offline.
Invalid AutoBoom XRT sensor
detected.
Left side sensor update.
Right side sensor update.
Left or Right sensor radar chip
failure.
Left sensor programming failure.
Recommended Actions
Check network settings.
Check ethernet connection and
cabling.
Update the SC1 ECU.
Cycle power to the VSN system.
Cycle power to the VSN system.
Rerun row spacing calibration.
Configure the radar sensors from
the setup page. Refer to the Radar
Settings section on page 36.
Check cabling.
Cycle power to the VSN system and
update VSN firmware.
Check cabling.
Cycle power to the VSN system and
update VSN firmware.
Update the height sensor.
Update the ABM ECU.
Calibrate or unlock AutoBoom XRT
ECU.
Check cabling.
Cycle power to the ABM ECU and
update ABM firmware.
Check cabling.
Cycle power to the ABM ECU and
update ABM firmware.
Invalid configuration. Ensure that
the tuneset is configured as a front
boom and the AutoBoom XRT
system is not present on the
ISOBUS.
Update the radar sensor firmware.
Update the radar sensor firmware.
Replace the radar sensor.
Retry programming the radar
sensor. Review the Update Sensor
section on page 42.
VSN® Operation Manual