Quick Start With Rasexpress - Multitech CommPlete 4000 Series User Manual

Quick Start with RASExpress

MultiTech Systems has preinstalled RASExpress server software on your CommPlete 4000 to
make configuration as simple as possible. For your convenience, a copy of the RASExpress
Installation program is on the CD-ROM shipped with the CommPlete 4000. Complete the
procedure below to put your CommPlete 4000 into operation as a Remote Access Server.
What you need to start
• The CommPlete 4000 Server
• A dumb terminal or an auxiliary PC (other than the CommPlete 4000 itself) that can
operate in terminal mode
• A shielded RS-232C serial cable with a female DB-9 connector on one end and a
connector to match the serial port of the terminal or auxiliary PC on the other end
(supplied)
• An IP Address assigned to the CommPlete 4000 server
• An IP Subnet Mask assigned to the CommPlete 4000 server
• Optional: a client PC connected to the CommPlete 4000’s network and equipped with
Telnet, a browser, or MultiManager
Accessing RASExpress
To configure the CommPlete 4000 as a RASExpress server, you must first connect a terminal
or auxiliary PC to the CommPlete 4000’s serial port. Then you must enable IP Remote
Access and program the IP Address and IP Subnet Mask into the CommPlete 4000. After
the IP Address and IP Subnet Mask have been entered into the CommPlete 4000, you can
either:
(a) continue using the terminal or auxiliary PC to program other network settings into the
CommPlete 4000, or
(b) re-boot the CommPlete 4000 and then continue programming the CommPlete 4000’s
network settings from a client PC connected to the LAN in which the CommPlete 4000 is
the RAS server.
Do this using Telnet, or a browser, or MultiManager.
The steps for both methods are presented below.
Method A. Do All Configuration using Terminal or Auxiliary PC
A1. Be sure that the CommPlete 4000 is connected to the LAN. Turn off the power for the
CommPlete 4000.
18
All manuals and user guides at all-guides.com
CommPlete 4000 Communications Server Overview