Board Removal And Replacement; Removing Sbc Board - Multitech CommPlete 4000 Series User Manual

Board Removal and Replacement

Removing SBC Board

1 Remove the CommPlete 4000 from rack enclosure (two people are needed). Follow the
procedure “Disconnecting Cables and Removal from Enclosure” presented above.
Summary: after powering down the unit and disconnecting all power and signal cables,
employ two persons to remove its rack-mounting screws and lift the unit out of the rack.
2 Remove the top cover from the CommPlete 4000 by removing the seven cover mounting
screws located in the back of the CommPlete 4000. (See Figure 4-3.)
3 Disconnect the four ribbon cables from the SBC. (See Figure 4-6.) Depending on
your configuration, you may not have all four ports in use.
CommPlete 4000 Communications Server Overview
All manuals and user guides at all-guides.com
B la c k
B la c k
B lu e
Y e ll o w
B la c k
B la c k
Figure 4-5b: Wire Colors and Orientation of Power Cables
B l a c k
B l a c k
B l u e
Y e l l o w
B l a c k
B l a c k
27