Multitech CommPlete 4000 Series User Manual page 21

B3. Power up the CommPlete 4000. The RASExpress Server Screen will appear.
Note: The server takes a few moments to load the RASExpress software and to initialize the
modems after it is turned on. Observe RAS software processing and displaying .
B4. Turn on the terminal (or auxiliary PC) and press Enter.
B5. Select Quick Configuration of Server.
B6. Enable IP Remote Access.
Note: Error messages will appear and will indicate that the remote addresses of the WAN ports
are not on the same subnet. This is normal for the initial setup. Ignore these messages.
B7. Type the IP Address for the CommPlete RASExpress server.
B8. Type the IP Subnet Mask.
B9. Re-boot the CommPlete 4000.
B10. Using Telnet for access requires that a TCP/IP protocol stack be loaded on the client PC.
Telnet access is possible both by dialing in through the RASExpress server and, more
commonly , through the LAN or Internet.
Client PC
running Telnet session,
web, or Windows
MultiManager
Figure 3-3. Setup for completing RASExpress configuration from client PC
At a client PC connected to the LAN in which the CommPlete 4000 is the RAS server, start
a Telnet session using either dial-in access or TCP/IP access.
CommPlete 4000 Communications Server Overview
All manuals and user guides at all-guides.com
SBC
Backplane
15-Pin Video
Connector
(to External
Display Monitor)
6-Pin Circular Jack
(To External Keyboard)
Figure 3-2: Serial port on the CommPlete 4000
CommPlete 4000
RASExpress Server
Connect RS-232C
Serial Cable (female end)
here
COM 1
DB9 male
RS-
232C
Cable
Dumb Terminal
or
Auxiliary PC
21