Multitech CommPlete 4000 Series User Manual page 19

A2. Using the provided RS-232C serial cable, connect a terminal (or an auxiliary PC) to the
CommPlete 4000’s serial port.
A3. Power up the CommPlete 4000. The RASExpress Server Screen will appear.
Note: The server takes a few moments to load the RASExpress software and to initialize the
modems after it is turned on. Observe RAS software processing and displaying .
A4. Turn on the terminal (or auxiliary PC) and press Enter.
A5. Select Quick Configuration of Server.
A6. Enable IP Remote Access.
Note: Error messages will appear and will indicate that the remote addresses of the WAN ports
are not on the same subnet. This is normal for the initial setup. Ignore these messages.
A7. Type the IP Address for the CommPlete RASExpress server.
A8. Type the IP Subnet Mask.
A9. In the IP Default Route field, enter the router address for the LAN’s file server.
A10. If you want the RASExpress server to use IP Routing Information Protocol (RIP-2) for IP
routing, enable IP RIP.
A11. If you have enabled IP-RIP, you may enable IP Auto Learn Default Gateway.
When enabled, the RASExpress server will learn the correct default gateway if it was
configured incorrectly or if the configured gateway goes down and a different router starts
acting as a default router.
A12. In the Primary Name Server field and the Secondary Name Server fields,
type 000.000.000.000
unless you have made other arrangements.
A13. In the IP Frame Type field, select TYPE_II (the default value).
CommPlete 4000 Communications Server Overview
All manuals and user guides at all-guides.com
SBC
Backplane
15-Pin Video
Connector
(to External
Display Monitor)
6-Pin Circular Jack
(To External Keyboard)
Figure 3-1: Serial port on the CommPlete 4000
Connect RS-232C
Serial Cable (female end)
here
COM 1
DB9 male
RS-
232C
Cable
Dumb Terminal
or
Auxiliary PC
19