Introduction; Disconnecting Cables And Removal From Enclosure - Multitech CommPlete 4000 Series User Manual

Introduction

This chapter’s procedures describe removal and replacement of the main hardware
components of the CommPlete 4000. Before removing or replacing any component, disconnect
the cables from the back of the CommPlete 4000 and remove the CommPlete 4000 from its
rack enclosure per instructions. The CommPlete 4000 has been designed to make this process
as efficient as possible, but if you experience problems, contact Multi-Tech Technical Support
(see chapter 6 of this section).

Disconnecting Cables and Removal from Enclosure

The steps below describe how to remove the CommPlete 4000 from its rack enclosure. These
steps must be followed before any internal component can be removed or replaced.
Warning: Anytime power is removed, turn off the Master Power switch inside the front door.
Note: In order to make re-connection easier, be sure to note or label all cable connections
before disconnecting any cables from the CommPlete 4000.
1 Remove the power cord from the back of the CommPlete 4000.
2 If connected, disconnect the video, COM 1, and keyboard cables from the back of the SBC.
Cover
3 If LAN is connected to the CommPlete 4000 , disconnect twisted-pair cable at the NIC.
4 Disconnect the telephone cords (RJ-12 and/or RJ-45) from the serial interface card(s).
Note: You may have ISI boards located in the left and right halves of the card cage
Caution: For safety and proper handling, two people are required to remove the CommPlete
4000 from its rack enclosure. Please work safely.
5 Remove the four rack enclosure mounting screws from the front of CommPlete 4000 and
Enclosure
Mounting Holes
24
All manuals and user guides at all-guides.com
Cover Mounting
Screws
Power Supply
Fig.4-1. Back Panel Connectors
remove the CommPlete 4000 from the rack enclosure. See Figure 4-2.
Single Processor
Communications Server
Fan Intake Vents
Handle
Fig. 4-2. Rack Enclosure Mounting Screws
ISI Boards
COM 2
(DB15)
Printer Port
(DB25)
SBC Backplane
Network
Interface
Card
Rack Enclosure
CommPlete 4000 Communications Server Overview
Mounting
Screws