MacDon M1 Series Unloading And Assembly Instructions page 159

6. For R113 SP: Remove the extra hydraulic quick couplers
from pressure hose (A) and return hose (B) and store them
as spares.
NOTE:
It is normal to have an extra set of quick couplers with the
rotary disc/draper ready configuration.
7. For R113 SP: Connect the hydraulic hoses to the windrower
with quick coupler fittings as follows:
a. Connect pressure hose female coupler to
receptacle (A).
b. Connect return hose male coupler to receptacle (B).
c. Connect case drain hose (C) to mating 1/2 in. coupler
on frame installed with the M1240 Low Pressure Case
Drain kit (MD #B6698). The other 1/2 in. flat faced
coupler for case drain (E) is NOT suitable for
the R113 SP.
d. Connect the electrical harness to receptacle (D).
8. For R216 SP: Connect hydraulic fittings to the hydraulic
hoses as follows:
a. Attach 90° elbow fitting (A) and 1 in. female coupler
fitting (B) to disc pressure hose (C).
b. Attach 90° elbow fitting (A) and 1 in. male coupler
fitting (D) to disc return hose (E).
215359
ATTACHING A HEADER TO AN M1 SERIES WINDROWER
149
B
Figure 5.84: Hydraulic Quick Couplers
D
Figure 5.85: R113 SP Hydraulics and Electrical –
Draper Ready
B
A
C
Figure 5.86: R216 SP Hydraulic Fittings
A
C
E
A
B
D
A
E
Revision A